Resmed Mirage Quattro Full Face Mask

Home/CPAP Equipment/CPAP Masks/Resmed Mirage Quattro Full Face Mask

Resmed Mirage Quattro Full Face Mask

Resmed Mirage Quattro full face mask is the industry standard CPAP mask. It has an adjustable forehead piece which helps with leaking into the eyes. Accommodates a wide range of movement during sleep and provides an effective solution for jaw drop. Comes in 4 sizes to accommodate many faces.

Categories: ,

Description

Mirage Quattro full face mask is the industry standard CPAP mask. It has an adjustable forehead piece which helps with leaking into the eyes. Comes in 4 sizes to accommodate many faces.

Size:

  • X-Small
  • Small
  • Medium
  • Large

Features:

  • Adjustable forehead support
  • Easy to fit mask seal
  • Accommodates a wide range of movement during sleep

Includes:

  • Frame
  • One Sized Cushion
  • Headgear
  • Instructions

***Warranty- 3 months

Adjustments:

Hold the frame with one hand and the headgear in the other. One of the headgear clips should be hooked into the frame. Place the seal over the mouth and then the nose and guide the headgear over the head. Hook the unattached headgear clip into the frame. Gently tighten the straps and the forehared support so there are no leaks.
* Do not over-tighten any of the headgear straps

Removal:
To take off the mask system, unclip the headgear from frame. Hold frame and guide straps over the head.

Disassembly:

Detach the air tubing. Unclip the lower headgear clips and unhook the upper headgear Straps. It is not necessary to remove the headgear clips from the headgear. Remove the elbow assembly from the mask frame. It’s easier to pivot the bottom of the elbow away from the mask frame than to pull the elbow straight off. Remove the valve clip from the elbow. Peel the valve away from the valve clip. Do not pull on the membrane to remove the valve. Detach the swivel from the elbow. Note the position on the dial for the next time you use the mask. Fully unscrew and remove the dial then pull the forehead support out of the mask frame. Remove the forehead support pads from the forehead support. Squeeze and push the upper side tabs on the cushion clip out of the mask frame. Pivot away from the mask, and gently pull out. Separate the cushion from the cushion clip. Remove the ports cap from the mask frame.

Resmed Cleaning Instructions:

Daily/After Each Use:

To optimize the mask seal, facial oils should be removed from the cushion before use.

Hand wash the mask by gently rubbing in warm (30°C) water using mild soap or diluted dishwashing detergent.

Do not twist the valve during cleaning as this may damage or tear the valve membrane or hinge. Take care when handling the valve.

If the vent requires cleaning use a soft bristle brush.

Rinse all components well with drinking quality water and allow them to air dry out of direct sunlight. Do not soak the mask.

Weekly:

Hand wash the headgear in warm (approx.30°C) water using mild soap or diluted dishwashing detergent. Rinse well and allow it to air dry out of direct sunlight.

** Do this in the morning as it will need to be dry for use that night.